EGM - No data from UdpUc device
Options
Dear all,
I am trying to set up communication between my linux computer and robot studio 6.0 using EGM. I am using the sample EGm code provided. I can ping the robot studio machine from my linux machine and vice versa. I get messages with updated time-stamps and feedback values from the robot studio. However I am getting the following error:
"No data from UdpUc device"
I have also tried increasing the \CommTimeout to 10 seconds and more but that does not help. Also the values of I am setting in "EgmPlanned planned" dont seem to be read by the controller.
0
Comments
-
I have fixed my error. It was a issue with UDP traffic on my network.0
-
Hi,
I am experiencing a similar issue and getting the same "No data from UdpUc device" error. Our control laptop doesn't seem to be sending UDP packets to the controller but I do have two-way communication to it because I can execute other parts of my code just fine. How did you pinpoint what was going wrong with your UDP traffic?
Thanks,
0
Categories
- All Categories
- 5.4K RobotStudio
- 385 UpFeed
- 15 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 285 IRC5
- 47 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 748 RAPID Programming
- 15 Wizard Easy Programming
- 110 Collaborative Robots
- 3 Job listings