EGM measuredForce and testSignals
csmith
✭
Looking at the egm.proto I can see that measuredForce and testSignals are defined messages, but I can't find any information about them.
What do those signals represent and how can they be set inside RS?
Thank you
What do those signals represent and how can they be set inside RS?
Thank you
0
Comments
-
You can see the measured force signal when you activate Force Control, e.g. using RAPID instruction FCAct. The controler then sends three measured force values and three measured torque values. I tested that on the real controler. Unfortunately I don't know what enforce the controler to send test signal values.
0 -
download RobotWare Tools and Utilities from RS website. Use Test Signal Viewer. See pages 110 , 327, 2328 in the FC Application Manual.0
Categories
- All Categories
- 5.4K RobotStudio
- 384 UpFeed
- 15 Tutorials
- 12 RobotApps
- 290 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 241 ScreenMaker
- 2.7K Robot Controller
- 283 IRC5
- 44 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 746 RAPID Programming
- 15 Wizard Easy Programming
- 110 Collaborative Robots
- 3 Job listings