Error setting TCP with virtual flexpendant

Togomi · February 2021

Hello,

I am trying to configure a tool and TCP with the virtual flexpendant in RS 6.08 as I were with the real robot, but when I try to finish, and error is shown.

I tried it with only points and with points and Z direction and the result is the same.

The message says someting like "Impossible to do the calibration with the current positions".

Does anyone try to do the same with RS?

Image: https://us.v-cdn.net/5020483/uploads/editor/xb/gisinc288z0e.png

Thanks in advance.

Greets

Maxim Riabichev · February 2021

Hello,

Please change your Windows language to English (install the necessary language pack from Microsoft) and try again.

This is a known bug.

Error setting TCP with virtual flexpendant

Comments

Categories

In this Discussion