RobotStudio event

OmniCore as EtherCAT slave?

Options
Fritz
Fritz ✭
in Robot Controller
Is there any ways to use OmniCore controller as EtherCAT slave for communication with PLC instead of Ethernet/IP ?
Any add-on cards? Rumors for near future?

Tagged:

Answers

  • kkNielsen
    kkNielsen ✭
    Options
    Hi Fritz,
    It seems that so far it can only be used with Ethernet/IP or ProfiNet.
    I haven't heard any rumors about EtherCat support. Maybe it is best to call your local ABB supplier to ask them about this.

  • Fritz
    Fritz ✭
    Options
    kkNielsen said:
    .... Maybe it is best to call your local ABB supplier ....


    No, definitely not. They give out far fewer rumors than on the forum. :)

Categories

In this Discussion