Signal Test Viewer
presage
✭
Can the Signal Test Viewer be used to monitor ROB_1?
I am trying to monitor the torque on the robot axis and whenever I enable and apply my channel settings I get the following message:
Error defining channel 1, unknown signal number 8
I am trying to monitor the torque on the robot axis and whenever I enable and apply my channel settings I get the following message:
Error defining channel 1, unknown signal number 8
- Cheers
0
Comments
-
I am a newbie here and just wanna say Hi to everyone. I am Daniel from Pennsylvania, US.
__________________
free photoshop tutorials
0 -
[Moderation: been requested to remove non-public information]Post edited by John Wiberg on0
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 301 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 338 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 832 RAPID Programming
- 14 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings