Forum Migration Notice
We're transitioning to a more modern community platform by the end of this year. Learn about the upcoming changes and what to expect.

ABB root jogging speed (through HMI)

SelenErsoy
SelenErsoy ✭
in RAPID Programming
Dear ABB family,

For my graduation project, i have to jog ABB-robot (IRB660) via the HMI. I also have to adjust the speed manually. Directions x y z is working well. 
I use the speed.tcp to adjust movement speed. 

Now i have to jog axis 4, the rotation. 
How can i adjust de rotation speed? Which movement command i should use MoveJ of MoveL?


I hope that my question is clear for you. I can send my code if it is needed.
Thank you in advance!

Selen Ersoy
Tagged:

Comments

  • graemepaulin
    graemepaulin ✭✭✭
    Try the RelTool function within a MoveJ  command.
    You can make the Robtarget the same as where the robot is currently , then use the rotation round the appropriate tool axis via the Reltool.
  • SelenErsoy
    SelenErsoy ✭
    @graemepaulin Thank you alot. I think this is exacly what i was looking for. With Reltool, i dont have to calculate quaternion to euler and back. just give the offset in degrees.

    Thank You!!
  • Micky
    Micky ✭✭✭
    The speed of the reorientation is set via the component "v_ori" in the data type "speeddata" independent of the used movement command.

    Quote from the manual of the chapter "speeddata":

    v_ori (velocity orientation)                     Data type: num
    The reorientation velocity of the TCP expressed in degrees/s.
    If a stationary tool or coordinated external axes are used, the velocity is specified relative to the work object.

Categories

In this Discussion