Palletizing PowerPac: Pick setting displays incorrect zoning due to tcp is out by 15degrees to tool0
Hi,
I am currently doing a project with PzPP that requires the tool to be out by 15deg relative to tool0.
Here is my tool config:

As shown above, pmPickTool1 is out by 15degrees relative to tool0. Now, since I did this, my pick setting looks horrendous:

Any way to fix this please?
Any comments appreciated! Thanks.
I am currently doing a project with PzPP that requires the tool to be out by 15deg relative to tool0.
Here is my tool config:

As shown above, pmPickTool1 is out by 15degrees relative to tool0. Now, since I did this, my pick setting looks horrendous:

Any way to fix this please?
Any comments appreciated! Thanks.
Tagged:
0
Categories
- All Categories
- 5.4K RobotStudio
- 375 UpFeed
- 15 Tutorials
- 12 RobotApps
- 286 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 241 ScreenMaker
- 2.7K Robot Controller
- 266 IRC5
- 40 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 722 RAPID Programming
- 15 Wizard Easy Programming
- 107 Collaborative Robots
- 3 Job listings