Signal Analyser- Simulation Time Problem
zyzyjulia
Germany ✭
in RobotStudio
Hello!
I am using Signal Analyser to confirm the exact braking time, when the robot stops with the fuction SafeMove(safe position supervision).
But the simulation time in Signal Analyser is so short, that I cannot see the speed and time values, wenn the robot stops. The corresponding area in Siganalanalyser is gray and I don't know why. Anyone else with this problem?
I am using Signal Analyser to confirm the exact braking time, when the robot stops with the fuction SafeMove(safe position supervision).
But the simulation time in Signal Analyser is so short, that I cannot see the speed and time values, wenn the robot stops. The corresponding area in Siganalanalyser is gray and I don't know why. Anyone else with this problem?
Tagged:
0
Categories
- 10.2K All Categories
- 5.2K RobotStudio
- 322 UpFeed
- 8 Tutorials
- 3 RobotApps
- 272 PowerPacs
- 401 RobotStudio S4
- 1.7K Developer Tools
- 236 ScreenMaker
- 2.6K Robot Controller
- 226 IRC5
- 26 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 675 RAPID Programming
- 12 Wizard Easy Programming
- 90 Collaborative Robots
- 3 Job listings