
50050 error

fengyuan
✭
in RobotStudio

Tagged:
0
Comments
-
The error is saying robot targets you created are out of reach which means the trans values(x, y, z) are bigger/longer than the robot arm length, 2.05m.
You therefore should reduce trans values of robot targets which create this error.
0 -
thank you innebandy
maybe the ques is not like you pointed,in the following link ,Henrik Berlin said it was the ' arm configuration' ,but I can't deal with it .Can you tell me how can i make it ? https://forums.robotstudio.com/discussion/4541/event-log-50050
0
Categories
- All Categories
- 5.4K RobotStudio
- 377 UpFeed
- 15 Tutorials
- 12 RobotApps
- 286 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 241 ScreenMaker
- 2.7K Robot Controller
- 270 IRC5
- 41 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 729 RAPID Programming
- 15 Wizard Easy Programming
- 108 Collaborative Robots
- 3 Job listings