Trying to access the Virtual controller via Ethernet IP
labu
✭✭
in RobotStudio
HI,
In order to have a digital twin of a solution we have using an ABB robot and a software PLC, we would like to use an EthernetIP link between our SoftPLC and the Virtual Controller.
Prior to try the hard way, I question the community about the ability of the Virtual Controller to do this.
Any help warmly welcomed.
In order to have a digital twin of a solution we have using an ABB robot and a software PLC, we would like to use an EthernetIP link between our SoftPLC and the Virtual Controller.
Prior to try the hard way, I question the community about the ability of the Virtual Controller to do this.
Any help warmly welcomed.
Tagged:
0
Comments
-
Post edited by rf_iasys on1
-
Hi, as fast as Buzz LightYear... THanks.0
-
Post edited by rf_iasys on0
Categories
- All Categories
- 5.6K RobotStudio
- 398 UpFeed
- 20 Tutorials
- 14 RobotApps
- 300 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 336 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 828 RAPID Programming
- 12 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings