Output goes off after power cut off

Ninad_Joshi
Pune ✭
Hello all, I am working on ABB robot with S4C+ controller. I have used SetDO instruction. When this instruction is run, the DO goes ON. But when I restart my controller or power cuts then after restarting, the DO goes off. Is there any setting I have to do in flexpendant ? Thank you.
0
Best Answer
-
Hello,In EIO parameters, you've got an attribute "store". With this activated, when your controller restart it restores your output state.5
Answers
-
I will implement it. Thank you.0
-
I implemented it and it worked. Thank you DenisFR0
Categories
- 10.3K All Categories
- 5.2K RobotStudio
- 341 UpFeed
- 13 Tutorials
- 6 RobotApps
- 281 PowerPacs
- 404 RobotStudio S4
- 1.7K Developer Tools
- 236 ScreenMaker
- 2.6K Robot Controller
- 238 IRC5
- 34 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 678 RAPID Programming
- 14 Wizard Easy Programming
- 100 Collaborative Robots
- 3 Job listings