Omnicore C30 -- System inputs don't show
Hi,
I have one controller Omnicore C30 witch comunicate with one Siemens PLC via Profinet interface.
I want to send to PLC, system signal PP to Main but on the I/O System Tab, doesn't appear System Inputs and System Outputs section.
How I can send to PLC this signal in this situation?
Thanks!
I have one controller Omnicore C30 witch comunicate with one Siemens PLC via Profinet interface.
I want to send to PLC, system signal PP to Main but on the I/O System Tab, doesn't appear System Inputs and System Outputs section.
How I can send to PLC this signal in this situation?
Thanks!
0
Comments
-
Check the controller tab.Systemintegrator - Web / C# / Rapid / Robotstudio
If I helped, please press Vote Up0
Categories
- All Categories
- 5.4K RobotStudio
- 375 UpFeed
- 15 Tutorials
- 12 RobotApps
- 286 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 241 ScreenMaker
- 2.7K Robot Controller
- 266 IRC5
- 40 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 722 RAPID Programming
- 15 Wizard Easy Programming
- 107 Collaborative Robots
- 3 Job listings