TSC – Torch Service Centre TC_96
in IRC5
Hello. We have an ABB robot and a welding tool service station. All the paths are programmed, and everything works fine. We moved the entire station to a new location and reprogrammed it. We created a system backup. However, when we restore the system from the backup, it restores the old paths that were for the previous location of the station, even though the backup was made after the station was moved to the new location,What is wrong with the programming related to the tool station?
0
Categories
- All Categories
- 5.5K RobotStudio
- 396 UpFeed
- 18 Tutorials
- 13 RobotApps
- 297 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 316 IRC5
- 60 OmniCore
- 7 RCS (Realistic Controller Simulation)
- 797 RAPID Programming
- AppStudio
- 3 RobotStudio AR Viewer
- 18 Wizard Easy Programming
- 105 Collaborative Robots
- 5 Job listings