Can't control the conveyor speed by using an analog signal
I have an issue with controlling the conveyor speed using an analog signal in Picking PowerPac. I followed the steps in Example 6.7 of the Picking PowerPac Application Manual. However, in the option Assigned to unit: PPASIM, I can only see PPABOARD01. When I continue until step 15, I still cannot control the conveyor speed.
Could you please advise me how to simulate the conveyor to start and stop sequentially?
Thank you very much for your support.
Tagged:
0
Categories
- All Categories
- 5.6K RobotStudio
- 401 UpFeed
- 21 Tutorials
- 15 RobotApps
- 306 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.9K Robot Controller
- 358 IRC5
- 77 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 851 RAPID Programming
- 29 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 110 Collaborative Robots
- 5 Job listings