SLOW RS [ArcWelding PowerPac]
Hi
When i in awpp to RS 5.09 test a singel target everything is ok,but id i chose multiple targets Roborstudion gets very slow andbegins to use a lot of cpu. Then i cant get in contakt for about 30 seconds forfore rs is done thinking.
Why is this, it dint happen in 5.08
Kent Zibrandtsen
Dept manager robot welding
Kez@hardi-international.com
Dept manager robot welding
Kez@hardi-international.com
0
Comments
-
hi again
sometimes it just chashes when this happen, and closes RS without giving the possibilty to save
Kent Zibrandtsen
Dept manager robot welding
Kez@hardi-international.com0
Categories
- All Categories
- 5.6K RobotStudio
- 401 UpFeed
- 21 Tutorials
- 15 RobotApps
- 304 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 354 IRC5
- 74 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 850 RAPID Programming
- 26 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 110 Collaborative Robots
- 5 Job listings