Binding geometries to tooldata and workobjectdata
Options
Hello,
I'm using a virtual station and I would like to make tooldata and workobjectdata constructs out of my imported geometries. How can I go about doing that?
I'm using Robot Studio 5.11.
Thank you,
Avital
I'm using a virtual station and I would like to make tooldata and workobjectdata constructs out of my imported geometries. How can I go about doing that?
I'm using Robot Studio 5.11.
Thank you,
Avital
0
Comments
-
Hi.Right click on your wobj and select "attach to". Then you will get a list of your cad modules to attach to.A usefull feather will designing your layout and test your reachabilyti.If you move your model your wobj will followBR. KlausBest Regards
Klaus Soenderhegn
www.cadalysator.dk0
Categories
- All Categories
- 5.4K RobotStudio
- 384 UpFeed
- 14 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 279 IRC5
- 46 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 736 RAPID Programming
- 15 Wizard Easy Programming
- 105 Collaborative Robots
- 3 Job listings