RobotStudio event

ENABLE RC MODE [ArcWelding PowerPac]

kentZibrandtsen
kentZibrandtsen ✭
in PowerPacs
when sync to vc from awpp it is poosible to chosse"  ENABLE RC MODE". but what does it meen?
Kent zibrandtsen
Hardi International A/S
Denmark

Comments

  • tysvenss
    tysvenss ✭
    From the manual
     Enable RC Mode

    Synchronization option.If selected, this option is enabled for all the tasks in the current station.It means that for variables that already exist in the virtual controller, synchronization will not override them. Only new variables will be created.

     

    RC mode can be used if you have a program in the VC that is loaded from a real controller and you want to add procedures and data to it without replacing whats there.

     

     
  • kentZibrandtsen
    kentZibrandtsen ✭

    ok thx very much. nice to know the different functions :)

    Kent zibrandtsen
    Hardi International A/S
    Denmark

Categories

In this Discussion