RobotStudio event

error during restore

dchayden
dchayden ✭✭
in RobotStudio S4

Howdy,

I'm trying to bring a virtual cell online that will exactly match my existing configuration, an IRB2400M98. I've got the cell physically "built" in Robot Studio 3.0 (build 2135), but I cannot get the virtual robot to take on the configuration of the real robot. I'm doing this by taking a current backup of the real robot and using that to "restore" the virtual robot.

I get the usual query that the profile for the restore (id'd by the robot's serial number) is different than the current profile (some generic name), and I choose to proceed anyway. The same goes for the robot type, the current robot type is a 2400-10kg M2000 and the restore unit is a 2400-16kg M98, again, I choose to proceed. Then I get a restore error 12033 stating that there was an error during the restore step Prepare on the SIO.cfg.image

Any thoughts?

 

Comments

  • dchayden
    dchayden ✭✭

    FYI:

    I scrapped everything, re-added the controller, keyfile, and parameters, and everything took this time... no explanation.

    At least it works. :)

    -DCH

Categories

In this Discussion