Moving Program Pointer to Line Number on S4CPlus
Don
✭
Hello,
I had a large program on an S4CPlus controller yesterday and wanted to move the program point to line 5200. Is there an easy way to do this? In manual mode, I could use the Edit menu to goto the top or bottom. In auto mode, I could move to a line number, but it moved the cursor and not the program pointer. When I returned to Manual mode, the cursor returned to the start of the program. In the end I pressed page down, many, many times.
Best regards,
Don.
I had a large program on an S4CPlus controller yesterday and wanted to move the program point to line 5200. Is there an easy way to do this? In manual mode, I could use the Edit menu to goto the top or bottom. In auto mode, I could move to a line number, but it moved the cursor and not the program pointer. When I returned to Manual mode, the cursor returned to the start of the program. In the end I pressed page down, many, many times.
Best regards,
Don.
0
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 301 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 338 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 832 RAPID Programming
- 14 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings