RobotStudio event

Adjusting stick-out in ArcWelding PowerPac [ArcWelding PowerPac]

TomR
TomR ✭
in PowerPacs

If I change the stick-out for a particular path, does it change the programmed position or the tool tcp position, or something else? 

Comments

  • TomR
    TomR ✭
    Anyone? 
  • KgaOfflineCenter
    KgaOfflineCenter ✭
    Hello TomR,
     

    It will change the target position.

     

    BR / Henrik
    Kga Offline Center www.kgaofflinecenter.se
    Offlineprogramming and simulation in RobotStudio and ArcWeld PowerPac

Categories

In this Discussion