Programming tab [Bending PowerPac]

CorreiaRS

hello guys,

I'm just trying to do a programming on Bendong PowerPac,  but something is missing to me.

I've defined layout and all tools, bendings, etc, but when I go to "programming" ribbon-rab, most of instructions are bloqued.



I can't find why.

any clue about this?

thank you

CorreiaRS

well, after a  couple of hours testing solutions with a teacher from FEUP (Portugal), I believe we understood the problem
I'm just trying everything from blank now to validade it

if all goes well, I will post here the solution for this problem


regards,