
Mirror of cutouts on carpet [KMT PowerPac]

in PowerPacs
Hello. I am programming a floorcarpet on KMT Cuttingbox. Is there any possibility to mirror the cutouts?
0
Comments
-
Hello Peter! Use the car-zero-frame as a mirrorplane and then just mirror all cutouts. Normaly you can also re-use middle and rear sections of the outer contour as well#1 Mark you floor carpet, right click and select "set as USC" or "als BKS setzen".#2 Select your path and right click choose path/mirror#3 select UCS / BKS as "reference" and "flip axis Y"Good luck!Best regardsConny0
-
by the way, see Chapter 3.8b about mirror-function in your training documentation0
Categories
- All Categories
- 5.5K RobotStudio
- 398 UpFeed
- 19 Tutorials
- 13 RobotApps
- 299 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 324 IRC5
- 63 OmniCore
- 7 RCS (Realistic Controller Simulation)
- 813 RAPID Programming
- 5 AppStudio
- 3 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 105 Collaborative Robots
- 5 Job listings