Problem with c-start
Hi, I tried to do a c-start, with bootmedia on a USB-device. But the controller restarts and loops throu 3 different screens, one saying: "Connecting to the robot controller", the other one saying "Loading image from robot system" and the last one says "Bootloader V2.08: decompressing image"
How can I get out of this loop, and get the system up and running again?
How can I get out of this loop, and get the system up and running again?
0
Comments
-
hmmmm. It seems that there is a hardware failer..Have you tried to load the bootmedia fram a PC connected to the service port?I think you should contact your local ABB service center if that doesen't workBest Regards
Klaus Soenderhegn
www.cadalysator.dk0
Categories
- All Categories
- 5.6K RobotStudio
- 398 UpFeed
- 20 Tutorials
- 13 RobotApps
- 300 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 330 IRC5
- 66 OmniCore
- 7 RCS (Realistic Controller Simulation)
- 826 RAPID Programming
- 9 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 105 Collaborative Robots
- 5 Job listings