Robot Controller Problem

bhurst

Ladies/Gentlemen,

I am having a serious problem with my setup. I had my station running fine, opened an old station just for referencing old cycle times, and now cannot seem to get my newer station to work. The software has imported all the old targets from the old station into my new one, and when I try to add configurations to my paths and synchronize them to the virtual controller and add to my simulation setup, it gives me a .NET exception error message that won't update my simulation.

I think it is having problems with my base frame definitions of the robots, I have tried updating the system configuration to fix this, but evidentially I am missing something. Anything guidance is much appreciated.

LangAmil

I'll definitely have the same problem if I start making one..