Synchronise to StationProcedures Not Showing Up

in RobotStudio
I have some procedures that just don't seem to show up in the synchronise to station list.
Any ideas why, I can run the program in robotstudio and it works fine, but the targets used in these procedures just arent visble anywhere in robotstudio. I have four procedures TouchProcA, TouchProc2A, TouchProcB, TouchProc2B, that are all very similiar just with a different robtarget (initial position) and search direction. And I cannot get these to show up in the list to synchronise.

0
Comments
-
HiI have the same effect if I use procedures with parameters.Best regardsMarcel0
-
yes that's it, all of my procedure with parameters don't appear.
Is this a known feature/bug?0 -
Hi All,This is a known feature/limitation in RobotStudio.We have it on our list for improvements for future releases.Best regards,
Anders Spaak
ABB Robotics0
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 301 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 336 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 830 RAPID Programming
- 13 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings