Unspecified error

leonardolt

Hi people.

Recently I was modifying and recovering some backups on my IRC5. As the working station setup changed during the project, it always ask me to recalibrate or update revolution counters if I choose a backup from a previous setup.
So, everything did normally until this mornig when I noticed I was not able to run any program anymore. My first opinion was that I had recovered a currupted backup I must have created. But this theory ran over when I recovered a healthy backup from 2 years before and the same error occured.
The most annoying point is that there is no message about what may have caused that fault in the event log or in anywhere else. I let here a picture of the message I receive from the controller and also the file generated by the system diagnostic tool.
I'll be very pleased if someone could help me on this.

webwiz/3195/SysDiagnosticsData.zip




Thanks
Leo

leonardolt

Well, I could not find the error's origin, but an I-Srart and a backup recovery solved the problem.

Leo