Program always running
Today I opened a simulation wich was always working fine but now I have the problem that the VC says program is running so I can't do anything in the Simulation-Enviroment nor on the Controller side. Of course I pressed the Stop Button and I resarted several times but the VC always starts the program when coming up and there is no way to stop it. Program is even running when motors are off.
Any ideas how to get access to my Simulation?
Best regards
Michael
Any ideas how to get access to my Simulation?
Best regards
Michael
0
Comments
-
Strange problem, the program can run with the motors are off.0
Categories
- All Categories
- 5.5K RobotStudio
- 390 UpFeed
- 18 Tutorials
- 13 RobotApps
- 297 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 249 ScreenMaker
- 2.7K Robot Controller
- 304 IRC5
- 59 OmniCore
- 7 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 772 RAPID Programming
- 17 Wizard Easy Programming
- 105 Collaborative Robots
- 4 Job listings