Sync to Station
in RobotStudio
Hello,
I have a problem. I have a backup of a real robot. I also have all the graphic environment in robotstudio. I want to load the coordinate system and targets from the real robot environment to the virtual environment. I want to do this with 'Sync to Station'.
When I do this all the workobjects are visible by 'Path&Targets' (the robtargets are not) but they are all in the baseframe of the robot. When I open the program in the Flexpendant all the workobject are on the correct position and I can move the robot to this position!
How is this possible?
Best Regards,
0
Categories
- All Categories
- 5.5K RobotStudio
- 398 UpFeed
- 19 Tutorials
- 13 RobotApps
- 299 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 324 IRC5
- 63 OmniCore
- 7 RCS (Realistic Controller Simulation)
- 813 RAPID Programming
- 5 AppStudio
- 3 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 105 Collaborative Robots
- 5 Job listings