Forum Migration Notice
Update (2026-01-21): The user forums are now in read-only mode pending the data migration.
Update (2026-01-12): The user forums will be put into read-only mode on the 21st of January, 00:00 CET, to prepare for the data migration.
We're transitioning to a more modern community platform by beginning of next year. Learn about the upcoming changes and what to expect.
Update (2026-01-12): The user forums will be put into read-only mode on the 21st of January, 00:00 CET, to prepare for the data migration.
We're transitioning to a more modern community platform by beginning of next year. Learn about the upcoming changes and what to expect.
Painting PowerPac 6.0 - setting Conveyor Tracking parameters problem
I followed instructions from Release notes for Painting PowerPac how to
set Start Window Width, but still when I start simulation, I get
warning: The workobject will never connect since the Start Window Width
is 0! Please change the value in the 'Configure Conveyor Encoder Unit'
dialog.
0
Best Answer
-
This is a know bug in version 6 of the PowerPac, its actually mentioned in the release notes. They only way I've found around it is to set the values using RS 5.61 with the relevant PP but if you've saved in RS6 then sometimes you can't open in a an older version.....
5
Categories
- All Categories
- 5.7K RobotStudio
- 402 UpFeed
- 21 Tutorials
- 16 RobotApps
- 307 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 251 ScreenMaker
- 2.9K Robot Controller
- 368 IRC5
- 92 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 859 RAPID Programming
- 43 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 111 Collaborative Robots
- 5 Job listings