RobotWare Spot; Dual Ped Simulatiion
I am trying to simulate only one of my guns on the dual ped but when I go into RobotWare Spot it only gives me the option to simulate both guns and not just the one I want. Any ideas on how to get around this other than writing a new program? (I am only trying to run one side of the cell, there is a left hand and right hand part, I only want to run LH in auto.)
0
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 300 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 336 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 828 RAPID Programming
- 12 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings