Improvement of sync to station
Hi,
if I change some tooldata by a rapid function (I do so with a self developed calibration routine) and want to sync the new tooldata to my station, I always first have to open the module the tooldata is stored in, make some change, compile the module and after this the correct new tooldata is synced to the station.
Otherwise (without changing and recompiling the module), the old tooldata is synced to the station.
I can Imaging that this is no simple issue to solve, but it would be a very great improvement for me.
Thanks and kind regards
Mike
if I change some tooldata by a rapid function (I do so with a self developed calibration routine) and want to sync the new tooldata to my station, I always first have to open the module the tooldata is stored in, make some change, compile the module and after this the correct new tooldata is synced to the station.
Otherwise (without changing and recompiling the module), the old tooldata is synced to the station.
I can Imaging that this is no simple issue to solve, but it would be a very great improvement for me.
Thanks and kind regards
Mike
0
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 301 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 337 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 831 RAPID Programming
- 14 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings