Stopping a Smart component's Linear Mover
sturner
✭✭
in RobotStudio
Hi
Once a linear mover is executed and a queue of parts are moving, is it possible to stop the linear mover, when a part hits a line sensor,
I would like to temporarily stop the queue of parts until a part is removed from the sensor?
Thanks in advance
Simon
Once a linear mover is executed and a queue of parts are moving, is it possible to stop the linear mover, when a part hits a line sensor,
I would like to temporarily stop the queue of parts until a part is removed from the sensor?
Thanks in advance
Simon
0
Comments
-
Simple just control the execute of the linear sensorPer Svensson
Robotics and Vision Specialist
Consat Engineering1
Categories
- All Categories
- 5.6K RobotStudio
- 399 UpFeed
- 20 Tutorials
- 14 RobotApps
- 300 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 336 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 828 RAPID Programming
- 12 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings