Fieldbus Ethernet Adapter Problem

in RobotStudio
Hello everyone,
I update my multimove system to 6.03 robotware version,
now...
I don't have any status blinking on the ethernet adapter in the controller with or without LAN cable connected to the board adapter in the cabinet.
The board and the net comunication was already tested before the update and was working properly.
I have follow the correct procedure to update the firmware and for migrate the backup.
I Attach photo and Backup of the system before and after migrated to the 6.03 firmware version.
I hope someone have a solution!
I update my multimove system to 6.03 robotware version,
now...
I don't have any status blinking on the ethernet adapter in the controller with or without LAN cable connected to the board adapter in the cabinet.
The board and the net comunication was already tested before the update and was working properly.
I have follow the correct procedure to update the firmware and for migrate the backup.
I Attach photo and Backup of the system before and after migrated to the 6.03 firmware version.
I hope someone have a solution!
0
Categories
- All Categories
- 5.6K RobotStudio
- 401 UpFeed
- 21 Tutorials
- 15 RobotApps
- 304 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 354 IRC5
- 74 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 850 RAPID Programming
- 26 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 110 Collaborative Robots
- 5 Job listings