Can I/O setup
SandB
✭
Hello Everyone, This is my first post.
I need suggestion about this topic : My company recently bought few ABB s4cplus Auto M2000A robots from some company. And I formatted old system and installed a new system, but the issue I'm facing its showing same old errors which I saw before the formatted system. Do I need to do rewiring control panel again reconfigure I/O setup ? Please let me know you opinion about it. And can give any suggestions or manual about wiring and I/O configuration setup it will be helpful. Thanks for you time Please advice me about errors. Link below is my error report.
https://www.dropbox.com/s/za561t42orrndk2/Classified%20Elog.txt?dl=0
I need suggestion about this topic : My company recently bought few ABB s4cplus Auto M2000A robots from some company. And I formatted old system and installed a new system, but the issue I'm facing its showing same old errors which I saw before the formatted system. Do I need to do rewiring control panel again reconfigure I/O setup ? Please let me know you opinion about it. And can give any suggestions or manual about wiring and I/O configuration setup it will be helpful. Thanks for you time Please advice me about errors. Link below is my error report.
https://www.dropbox.com/s/za561t42orrndk2/Classified%20Elog.txt?dl=0
0
Categories
- All Categories
- 5.6K RobotStudio
- 398 UpFeed
- 20 Tutorials
- 14 RobotApps
- 300 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.8K Robot Controller
- 336 IRC5
- 67 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 828 RAPID Programming
- 12 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 107 Collaborative Robots
- 5 Job listings