offset help

we have a machine which has lots of pick-up drop-off targets, now once very few hundred the robot grippers drops a part and the robot gets stuck in an hard place to recover from, (for the operators anyway)all that is needed is for the robot to drive vertically about 300mm then it is clear of the obstructions.  so i thought i would have a go at writing a small recovery program

--------------------------------------------------------------------------------------------------------------------

 PROC Recovery()

  !wrote by gareth thwaite to
aid recovery

 ! set slow speed for recovery

  CONST speeddata
GarethSpeed:=[500,500,500,500];

  !+++++++++++ var position for
recovery++++++++++++++

  VAR robtarget recovery1;

  CONST robtarget
pabovetray:=[[349.48,-934.95,854.23],[0.0237752,0.716986,0.695494,0.0406639],[-1,0,0,0],[9E+09,9E+09,9E+09,9E+09,9E+09,9E+09]];

  CONST robtarget
phalfhome:=[[391.49,-337.97,854.23],[0.023777,0.716985,0.695495,0.0406651],[-1,0,0,0],[9E+09,9E+09,9E+09,9E+09,9E+09,9E+09]];

    WaitTime 0.8;

   recovery1:=
crobt( ool:=tool0WObj:=wobj0);

   MoveL
reltool,(recovery1,0,0,-300),GarethSpeed,fine,tool0WObj:=wobj0; 

   MoveJ
pabovetray,garethspeed,fine,tool0;

   MoveJ
phalfhome,garethspeed,fine,tool0;

   MoveJ pHome, vCycle,
fine, tool0WObj:=wobj0;

   waittime 5;

   main;

  ENDPROC  

ENDMODULE

---------------------------------------------------------------------------------------------------------------

the porblem is i dont know the command to move it with an offset relative to the world/robot rather than the tool, 

can anyone help?