Event Tables
Options
I am new to RobotStudio and I am trying to create an event table specific to a given path. How do I do this? The robot follows the path but does not carry out actions specified in the event table such as "attach stay". Would appreciate some help.
RMO
0
Comments
-
You could add an I/O signal that is set programatically during the path procedure, and use that to trigger the event.
regards,
Johannes
Johannes Weiman
Software Engineer
ABB Robotics0
Categories
- All Categories
- 5.4K RobotStudio
- 384 UpFeed
- 14 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 279 IRC5
- 46 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 734 RAPID Programming
- 15 Wizard Easy Programming
- 105 Collaborative Robots
- 3 Job listings