Forum Migration Notice
We're transitioning to a more modern community platform by the end of this year. Learn about the upcoming changes and what to expect.
Yumi overheating?
in RobotStudio
Hello everyone,
I've got question related to YuMi robot.
I made simple program for both arms to move and open/close smart gripper - after about 100 cycles I've stopped robot and touch it near the place where smart gripper is connected to robots arm - i found out that there's a place which is very warm - I'd say it's even little bit burning - is this normal that it heats-up so much?
I've got question related to YuMi robot.
I made simple program for both arms to move and open/close smart gripper - after about 100 cycles I've stopped robot and touch it near the place where smart gripper is connected to robots arm - i found out that there's a place which is very warm - I'd say it's even little bit burning - is this normal that it heats-up so much?
0
Comments
-
Anyone?0
-
We have had our YuMi running for 8 hours continuously and not had any problems with heat..0
Categories
- All Categories
- 5.6K RobotStudio
- 401 UpFeed
- 21 Tutorials
- 15 RobotApps
- 306 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.9K Robot Controller
- 365 IRC5
- 84 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 854 RAPID Programming
- 37 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 110 Collaborative Robots
- 5 Job listings