How to use PoseMover to move a Device to specific Pose?
Options
in RobotStudio
#Educational License
Hi there,
Had tried to use the PoseMover component on a Device and activate it directly from Rapid, however nothing happens.
The used configuration is a:
Fully Functional Mechanical "Device" with all transition times, joints, etc properly configured, added as component to a SmartComponent with PoverMovers and Highlighters only.
For each PoseMover an input & output is connect to a input & output @ the controller.
To activate the SmartComponent [Input] that is connected to the poseMover, had tried pulseDO and setDO methods, none of them work...
Can this be done ?? or it just seems nice but it´s not possible on RobotStudio ?
There is always the possibility to do it with the Event table, however this way we would be able to control the entire station directly from Rapid.
Please advice if some specific configuration is required to perform this operation.
Thank´s on advanced,
Victor
Hi there,
Had tried to use the PoseMover component on a Device and activate it directly from Rapid, however nothing happens.
The used configuration is a:
Fully Functional Mechanical "Device" with all transition times, joints, etc properly configured, added as component to a SmartComponent with PoverMovers and Highlighters only.
For each PoseMover an input & output is connect to a input & output @ the controller.
To activate the SmartComponent [Input] that is connected to the poseMover, had tried pulseDO and setDO methods, none of them work...
Can this be done ?? or it just seems nice but it´s not possible on RobotStudio ?
There is always the possibility to do it with the Event table, however this way we would be able to control the entire station directly from Rapid.
Please advice if some specific configuration is required to perform this operation.
Thank´s on advanced,
Victor
Tagged:
0
Answers
-
My experience is that, with RobotStudio 6.04, the pose mover only works in Simulation mode, i.e. program is not started from RAPID or virtual flex pendant. Therefore I normally sync to station first, and then run the program from Simulation tab and hit Start/Play simulation button.0
Categories
- All Categories
- 5.4K RobotStudio
- 385 UpFeed
- 15 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 285 IRC5
- 47 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 748 RAPID Programming
- 15 Wizard Easy Programming
- 110 Collaborative Robots
- 3 Job listings