IRC5
joaoeq
✭
in RobotStudio
Hello everyone
I am new to robot programming, and I would like to know if it is possible to start the work cycle on IRC5 without using Flexpendant?
For example: Start/Stop, Reset, Home Position...
For example: Start/Stop, Reset, Home Position...
Any information is welcome
Thank you
0
Comments
-
You use the system inputs (and if you want feed back from the controller on its status use the system outputs).
I have attached extracts from the System Parameters manual on these topics.0 -
Hi graemepaulin
Thank you very much for the information, now I have a north to follow
0 -
Thanks for the info graemepaulin, it helped0
Categories
- All Categories
- 5.6K RobotStudio
- 401 UpFeed
- 21 Tutorials
- 15 RobotApps
- 306 PowerPacs
- 407 RobotStudio S4
- 1.8K Developer Tools
- 250 ScreenMaker
- 2.9K Robot Controller
- 363 IRC5
- 81 OmniCore
- 8 RCS (Realistic Controller Simulation)
- 853 RAPID Programming
- 31 AppStudio
- 4 RobotStudio AR Viewer
- 19 Wizard Easy Programming
- 110 Collaborative Robots
- 5 Job listings