Issue with Profinet configuration

Luxrobotic

Luxrobotic

There is 2 robots connected to PLC

Luxrobotic

There is 2 robots connected to PLC

Luxrobotic

There is 2 robots connected to PLC

lemster68

OK.  So, the profinet gateway address from the last configuration is the IP address of this switch?

Luxrobotic

Hello,

sorry for the late reply.

The Ip address of the DSQC-678 board is 192.168.10.51

lemster68

Hello again.  Have you added the EIO_UNIT for the IO, PN_INTERNAL_SLAVE Unit Type?  And the switch IP address matches the gateway IP address? 

Luxrobotic

We are not able to change the current IP address which is 192.168.1.100.

As I understood we could only make by generating a xdb file with the PLC software, that we didn't succed until now.

lemster68

There may be a misunderstanding here.  I am not asking you to change the switch IP address, just make the gateway in the EIO.cfg match the switch address.

Luxrobotic

If I set the IP address in the cfg file, the PLC doesn’t see the change. This should be linked to the xdb file where the address is still  192.168.1.100.

lemster68

Have you created the EIO_UNIT in your EIO?

Luxrobotic

The robot is a used one,  the config was in the controller

lemster68

Last thing to ask:  Have you managed to name the station in profinet using some kind of profinet configuration tool?

Luxrobotic

That's the problem we have, we did a lot of tests, without success. Only one time, but just for a few minutes.

We can't make any change on IP address or name