Program does not execute continuously in the Main Module
Options
Hi,
I'm having a problem running the program continuously in PROC main ( ). When the controller is switched to Automatic Mode it executes the program in the PROC main ( ) but it stops after the program finishes and does not run continuously as it should.
I'm having a problem running the program continuously in PROC main ( ). When the controller is switched to Automatic Mode it executes the program in the PROC main ( ) but it stops after the program finishes and does not run continuously as it should.
Tagged:
0
Comments
-
Is the run mode (middle of RAPID tab) in continuous?0
-
You know, you are not required to be so specific about your location in your profile...Lee Justice0
-
graemepaulin said:Is the run mode (middle of RAPID tab) in continuous?
I'm not sure what you mean0 -
0 -
graemepaulin said:0
Categories
- All Categories
- 5.4K RobotStudio
- 383 UpFeed
- 14 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 279 IRC5
- 46 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 733 RAPID Programming
- 15 Wizard Easy Programming
- 105 Collaborative Robots
- 3 Job listings