Pickmaster RIS Proxy setup to Compact Logix AB PLC
Options
curtis24
✭
Hey all,
I recently setup a single pick and place flexpicker robot cell. I want to get the RIS setup working to start and stop the pickmaster project from the PLC. After I configure the RIS setup on the Pickmaster PC what do I need to do or add on the PLC end to read the data in and send the data out. Do I need to install something further other than RIS on the pickmaster PC? any help to complete this would be appreciated.
0
Comments
-
Hi Curtis, Did you get any info...i'm stock with the same problem?
0
Categories
- All Categories
- 5.4K RobotStudio
- 384 UpFeed
- 14 Tutorials
- 12 RobotApps
- 291 PowerPacs
- 406 RobotStudio S4
- 1.8K Developer Tools
- 247 ScreenMaker
- 2.7K Robot Controller
- 279 IRC5
- 46 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 736 RAPID Programming
- 15 Wizard Easy Programming
- 105 Collaborative Robots
- 3 Job listings