Encoding Rapid Files
Hey All.
I want to encode my Rapid source code such that it cannot be viewed by anyone else. How do I do this. Can anyone please help??
Thank You
Justin
0
Comments
-
Hi,
I have a software to encode the modules. Send to me a private mensage with your email adress and I give to you a software!
Best regards,
Joao Fidalgo
0 -
-
0
-
-
0
-
-
0
-
0
-
HI,
I am intrusted in this software
can you pl send it to me on [email protected]
warm regards
Pankaj Sharma
A P Controls
0 -
Just as a note for you guys who are thinking about security. Encrypting your entire hard drive will provide you with the best protection (that and intelligent operating). You could set it up to have a separate partition to store data in, that could require a different password, or a key file on a USB or SD card.
I've used Truecrypt with great success on both Windows and Linux. Just make sure that if you go this route that you back up any valuable data and set up your system to run (if it is operational) without that computer while you do this. This will require you to re-install your system on the encrypted drive, but if you make a backup, it is no big deal.
0 -
0
-
-
0
-
Hi,I will have thge same problem, i need to encrypt my Rapid Programs for IRC5.Have you got the encrytor ??ThanksSonce0
-
0
-
0
-
-
Hi Joi,
I have been searching for long the software that could be used to encode a RAPID programs.Can you please send it to me?
E-mail: [email protected]
Thanks,
Vikas
0 -
Best wishes
Ashwin Gomes
Automation Eng/ KTP Associate
PMS Diecasting / Sheffield Hallam University
Rotherham / Sheffield ,
S0 -
Best regards
Alexander Källberg0 -
Dear Joi,Can you please send me the encoding files to my email address [email protected]Thanks,Vikas0
-
is there anyway someone could just upload it here, so everyone has access to it more easily?Dustin0
-
0
-
0
-
0
-
HiHere is the software to encode. It is 10 years old but still works.
Hint: Don't change the recommended directory: C:encode to put these files in.
Hint: There is no way back (decoding). So keep the original program code.
Best regardsMarcel0 -
Thank you Marcel for the softwareOnly God Can Judge Me0
-
I'm need encode modul bullseye.sys This program is unworkable.Please help me ...
0
Categories
- All Categories
- 5.4K RobotStudio
- 375 UpFeed
- 15 Tutorials
- 12 RobotApps
- 286 PowerPacs
- 405 RobotStudio S4
- 1.8K Developer Tools
- 241 ScreenMaker
- 2.7K Robot Controller
- 266 IRC5
- 38 OmniCore
- 6 RCS (Realistic Controller Simulation)
- 3 RobotStudio AR Viewer
- 717 RAPID Programming
- 15 Wizard Easy Programming
- 107 Collaborative Robots
- 3 Job listings