Discussion List

• Omnicore Profinet

  78 views 0 comments 0 points Started by IQUTEC August 15 RobotStudio
• Profinet configuration causes connection problem with other devices over wan port.

  209 views 1 comment 0 points Most recent by Tompanhuhu April 9OmniCore
• RSConnectDIOToSnap7 TCP error

  435 views 4 comments 0 points Most recent by BJaws April 2023RobotStudio
• Writing from virtual controller Profinet signals to PLC through OpcUa

  422 views 2 comments 0 points Most recent by dragolollo February 2023RobotStudio
• Analog I/O signal mapping for PROFINET

  2.9K views 1 comment 0 points Most recent by aremus April 2021Robot Controller
• How to properly setup a PROFINET device with a given GSDML

  10.6K views 5 comments 0 points Most recent by aremus April 2021RobotStudio
• Safety Checksum To PLC

  739 views 2 comments 0 points Most recent by Micky March 2021IRC5
• LAN port for Profinet with option 883?

  524 views 2 comments 0 points Most recent by lemster68 March 2021IRC5
• Check Profinet Connection to PLC?

  710 views 4 comments 0 points Most recent by Paba October 2019RobotStudio
• Connect to IRC5 & PLC over network

  1.3K views 4 comments 0 points Most recent by Paba September 2019IRC5
• S7-1500 communicate with virtual IRC5?

  233 views 0 comments 0 points Most recent by Paba July 2019IRC5
• TIA Portal example project with Siemens PLC as master and IRC5 as slave over PROFINET

  4.2K views 1 comment 0 points Most recent by Moises May 2019Robot Controller
• Event message 71362

  1.6K views 2 comments 0 points Most recent by jboti October 2018Robot Controller
• Profinet. Problem with connection

  874 views 1 comment 0 points Most recent by Richard Ramos July 2018RobotStudio
• Siemens 317F PROFINET Can't connect

  258 views 3 comments 0 points Most recent by daguilar May 2018Robot Controller
• SafeMove2 GSD file error

  1.9K views 5 comments 1 point Most recent by Polszenager April 2018Robot Controller
• Profinet connection [MOVED]

  108 views 0 comments 0 points Most recent by Ercan May 2014Robot Controller
• Why there is profinet cable on SpotGun?

  8 views 0 comments 0 points Most recent by ErcanMenekse May 2013Robot Controller